From 81eb11e28519f5a2bb83a2c207fe46b8ec4b9258 Mon Sep 17 00:00:00 2001 From: Kenneth Privitt Date: Wed, 2 Sep 2026 15:24:55 -0700 Subject: [PATCH] Doc change to clarify radio setting country reqs. --- docs/cli_commands.md | 10 +++++++--- 1 file changed, 7 insertions(+), 3 deletions(-) diff --git a/docs/cli_commands.md b/docs/cli_commands.md index 4ccdd8d1..0977347f 100644 --- a/docs/cli_commands.md +++ b/docs/cli_commands.md @@ -215,7 +215,8 @@ This document provides an overview of CLI commands that can be sent to MeshCore **Note:** Requires reboot to apply -**Notes:** These settings control the setup of the radio parameters.Refer to the node's manual for the correct settings to use. +**Notes:** These settings control the setup of the radio parameters. +Refer to the node's manual for the correct settings to use. **Setting a value too high or too low may violate the laws in your country.** --- @@ -232,7 +233,9 @@ This document provides an overview of CLI commands that can be sent to MeshCore **Default:** Varies by board -**Notes:** This setting only controls the power level of the LoRa chip. Some nodes have an additional power amplifier stage which increases the total output. Refer to the node's manual for the correct setting to use. **Setting a value too high may violate the laws in your country.** +**Notes:** This setting only controls the power level of the LoRa chip. Some nodes have an additional power amplifier stage which increases the total output. +Refer to the node's manual for the correct setting to use. +**Setting a value too high may violate the laws in your country.** --- @@ -247,7 +250,8 @@ This document provides an overview of CLI commands that can be sent to MeshCore - `cr`: Coding rate (5-8) - `timeout_mins`: Duration in minutes (must be > 0) -**Notes:** These settings control the setup of the radio parameters.Refer to the node's manual for the correct settings to use. +**Notes:** These settings control the setup of the radio parameters. +Refer to the node's manual for the correct settings to use. **Setting a value too high or too low may violate the laws in your country.** **Note:** This is not saved to preferences and will clear on reboot