diff --git a/docs/cli_commands.md b/docs/cli_commands.md index 8772b929..4ccdd8d1 100644 --- a/docs/cli_commands.md +++ b/docs/cli_commands.md @@ -215,6 +215,9 @@ This document provides an overview of CLI commands that can be sent to MeshCore **Note:** Requires reboot to apply +**Notes:** These settings control the setup of the radio parameters.Refer to the node's manual for the correct settings to use. +**Setting a value too high or too low may violate the laws in your country.** + --- #### View or change this node's transmit power @@ -244,6 +247,9 @@ This document provides an overview of CLI commands that can be sent to MeshCore - `cr`: Coding rate (5-8) - `timeout_mins`: Duration in minutes (must be > 0) +**Notes:** These settings control the setup of the radio parameters.Refer to the node's manual for the correct settings to use. +**Setting a value too high or too low may violate the laws in your country.** + **Note:** This is not saved to preferences and will clear on reboot --- @@ -575,6 +581,9 @@ This document provides an overview of CLI commands that can be sent to MeshCore > **Note:** Added in firmware v1.15.0 +**Notes:** Refer to the node's manual for the correct settings to use. +**Setting a value too high may violate the laws in your country.** + --- #### View or change the airtime factor (duty cycle limit)