Boards own their FEM control through handleCommand() ("get/set
radio.fem.rxgain|txgain"). Use that instead of a parallel set of FEM
virtuals on MainBoard, so any board that implements the commands works
in KISS with no extra code.
- Remove the six FEM virtuals from MainBoard and the board overrides.
- KissModem talks to the board in one adapter. A gain counts as
controllable only if "get" replies exactly "> on" or "> off". "set"
is checked by reading the state back, never by its reply wording.
- SetFemState always replies with the read-back state once the
requested bits pass the capability check.
- Guard the boards' prefs writes against a NULL store. KISS attaches
no prefs, so "set radio.fem.*" would dereference NULL.
- Wio Tracker L1 1W TX gain is exposed again, matching its CLI.
Add SetHardware sub-commands so a host can probe and configure
per-board RF front-end settings:
- GetCapabilities (0x1B): uint32 feature bits (AGC, FEM RX, FEM TX)
- Set/GetAgcResetInterval (0x1C/0x1D): 0-1020 s, 4 s resolution,
0 disables; default stays 30 s
- Set/GetFemState (0x1E/0x1F): apply/value masks for FEM RX (LNA)
and TX (PA) gain; all-or-nothing, Unsupported (0x08) if any
requested bit is not controllable on this board
The AGC scheduler moves from main.cpp into KissModem so it is
configurable and unit-tested. FEM changes that arrive mid-TX are
deferred until the packet ends, since board setters drive FEM pins
directly.
MainBoard gains virtual FEM hooks (canControl/set/is for LNA and PA
gain). Boards that already implemented these methods privately now
expose them as overrides: Heltec V4, V4 R8, T096, Tracker V2,
Station G3 and Wio Tracker L1 1W.
KISS_FIRMWARE_VERSION bumped to 2.
Switch ESP32-S3 KISS modem environments to HWCDC and move outbound KISS writes to a non-blocking queued frame path so loop() and TX completion keep progressing when the host reads slowly. Add native backpressure regression tests and correct the native_kiss_modem test filter so this suite runs directly with pio test.
hasSeen() was simultaneously a predicate and a mutator — it inserted the
packet hash on every miss, making five call sites that only wanted to mark
a packet as sent call it with the return value discarded.
Split into:
- wasSeen() — pure predicate, no side effects
- markSeen() — explicit insert
All query sites now call markSeen() immediately after wasSeen() returns
false, preserving identical runtime behaviour. The five mark-only send
sites (sendFlood, sendDirect, sendZeroHop x2) now call markSeen directly.
Also fixes three bridge sites (BridgeBase, ESPNowBridge, RS232Bridge)
that had the same query+implicit-insert pattern.
Tests: add test/test_mesh_tables/ covering wasSeen purity, markSeen,
dup stats, and clear. Update SHA256 mock to produce deterministic output
(previously finalize() was a no-op). Add Packet.cpp to native build filter.