Files
meshcore-tth/examples/simple_repeater
tthandClaude Opus 5 5333a71927 fix(tools/ble_dfu): require the target address; feat: ble_cli.py; feat: silent-by-default repeater
ble_dfu find(): with want_dfu it accepted ANY device whose name contained "DFU"
and then took the first one the scan returned. With more than one board in
bootloader at the same time that reaches for someone else's hardware. It just
did: target CE:72:…:02, connected FE:11:…:C4. Caught only because the log was
being read by hand -- a few seconds later START_DFU would have overwritten a
different node. The address is now mandatory (MAC or MAC+1, covering both the
SCAP_DFU-on-MAC+1 and AdaDFU-on-same-MAC bootloaders), and foreign boards in
bootloader are listed as explicitly ignored.

ble_cli.py: the BLE console had no tool, so every ad-hoc script re-implemented
it and re-learned the same trap: a NUS write carries ATT_MTU-3 bytes and BlueZ
will not split it, so at the usual MTU 23 anything over 20 bytes fails with
"Failed to initiate write" -- which reads like a dropped link, not "command too
long". Commands up to 18 chars work, longer ones fail, deterministically.
Chunking is now in one place, with retries and the pairing/single-console
caveats documented.

simple_repeater: ADVERT_INTERVAL_DEFAULT / FLOOD_ADVERT_INTERVAL_DEFAULT /
DISABLE_FWD_DEFAULT, so a node can be built to ship silent. ENABLE_ADVERT_ON_BOOT
alone is not enough -- it only suppresses the boot advert, the periodic timer
still fires, so an `erase`d node is on the air within two minutes. Found the
hard way: a node flashed before this change and then erased spent ~44 s
transmitting on the live CZ frequency from a desk.

Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
2026-08-03 21:46:23 +02:00
..