Repeater, room server, sensor (nRF52): get chip tells the silicon and whether SWD can read the flash
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
1 parent
ac49cd6621
commit
b30cda7936
2 files changed
+15
No files matched your search
@@ -113,6 +113,7 @@ stall watchdog", "Reboot into the bootloader" and "Why the board last reset".
|
||||
| `blink [n]` / `blink on\|off` | repeater | flash a spare LED (not the BLE or TX one) `n` times (default 6, max 999), or until `blink off` (gives up after 10 min); finds a board on a bench or a node on a mast |
|
||||
| `txpwr [dBm]` | repeater | LoRa output power until reboot, with RadioLib's status (`set tx` saves and says OK even when the radio refused) |
|
||||
| `i2c` | all | scan the I2C bus |
|
||||
| `get chip` | nRF52 (repeater, room server, sensor) | the silicon (`nRF52840 AAD0`; variant `xxF0` and later = rev3) and `UICR.APPROTECT`: `open` means SWD can read the whole flash, keys included ([locked-bootloader.md](locked-bootloader.md)) |
|
||||
| `dio1` | own build: `PIN_DIAG` | has the SX1262 raise TX_DONE and compares its IRQ register with the level on the DIO1 pin -- which end of a dead IRQ line is broken |
|
||||
| `radiostat` | own build: `RADIO_DIAG` | receiver state, interrupt and RX counters, without touching the radio |
|
||||
| `radiokick rx\|clrirq\|standby\|agc` | own build: `RADIO_DIAG` | one recovery step, gentlest first: re-arm RX, clear latched IRQs, standby + RX, AGC reset; the first that brings `recv` back names the broken layer |
|
||||
|
||||
@@ -936,6 +936,20 @@ void CommonCLI::handleGetCmd(uint32_t sender_timestamp, char* command, char* rep
|
||||
strcpy(reply, "Error: locked build");
|
||||
return;
|
||||
}
|
||||
#endif
|
||||
#if defined(NRF52_PLATFORM)
|
||||
// CUSTOM (TeTeHacko): which silicon, and whether SWD can read the flash
|
||||
// (docs/locked-bootloader.md, point 5). Variant xxF0 and later = rev3, where
|
||||
// the hardware closes the debug port unless the firmware opens it on every
|
||||
// boot -- ours never does; rev1/rev2 obey UICR.APPROTECT alone (0xFF = open).
|
||||
if (memcmp(config, "chip", 4) == 0 && config[4] == 0) {
|
||||
uint32_t v = NRF_FICR->INFO.VARIANT;
|
||||
uint32_t ap = NRF_UICR->APPROTECT;
|
||||
sprintf(reply, "> nRF%lx %c%c%c%c, uicr.approtect %08lx (%s)", (unsigned long)NRF_FICR->INFO.PART,
|
||||
(char)(v >> 24), (char)(v >> 16), (char)(v >> 8), (char)v, (unsigned long)ap,
|
||||
(ap & 0xFF) == 0xFF ? "open" : "protected");
|
||||
return;
|
||||
}
|
||||
#endif
|
||||
if (memcmp(config, "allow.read.only", 15) == 0) {
|
||||
sprintf(reply, "> %s", _prefs->allow_read_only ? "on" : "off");
|
||||
|
||||
Reference in new issue
Block a user